| Age | Commit message (Collapse) | Author |
|---|
|
This doesn't allow all tests to run cleanly, but it at least allows to
write tests which could run successfully in such environments.
Git-Dch: Ignore
|
|
We use test{success,failure} now all over the place in the framework, so
its only consequencial to do this in the situations in which we test for
a specific output as well.
Git-Dch: Ignore
|
|
These functions check the exit code of the command, but for apt commands
we can go further and require an error message for non-zero exits and
none for zero exits.
Git-Dch: Ignore
|
|
Previously, we had a start and a done of the calculation printed by
higher-level code, but this got intermixed by progress reporting from an
external solver or the output of autoremove code…
The higherlevel code is now only responsible for instantiating a
progress object of its choosing (if it wants progress after all) and the
rest will be handled by the upgrade code. Either it is used to show the
progress of the external solver or the internal solver will give some
hints about its overall progress. The later isn't really a proper
progress as it will jump forward after each substep, but that is at
least a bit better than before without any progress indication.
Fixes also the 'strange' non-display of this progress line in -q=1, while
all others are shown, which is reflected by all testcase changes.
|
|
As outlined in #748355 apt segfaulted if it encountered a loop between a
package pre-depending on a package conflicting with the previous as it
ended up in an endless loop trying to unpack 'the other package'.
In this specific case as an essential package is involved a lot of force
needs to be applied, but can also be caused by 'normal' tight loops and
highlights a problem in how we handle breaks which we want to avoid.
The fix comes in multiple entangled changes:
1. All Smart* calls are guarded with loop detection. Some already had it,
some had parts of it, some did it incorrect, and some didn't even try.
2. temporary removes to avoid a loop (which is done if a loop is
detected) prevent the unpack of this looping package (we tried to unpack
it to avoid the conflict/breaks, but due to a loop we couldn't, so we
remove/deconfigure it instead which means we can't unpack it now)
3. handle conflicts and breaks very similar instead of duplicating most
of the code. The only remaining difference is, as it should:
deconfigure is enough for breaks, for conflicts we need the big hammer
|
|
Git-Dch: Ignore
|
|
|
|
|
|
|
|
|
|
|
